AMD stock coolers tested: Wraith Prism vs. Wraith Spire vs. Wraith Stealth

ebn benghazi
[ad_1]






AMD outperformed the game with processor coolers in stock that it bundled with Ryzen processors and they relaunched another notch with Ryzen 2nd generation that come with one of the three Wraith models that we compare today. 39: Hui: the Stealth, Spire and Prism.



The most expensive Ryzen 7 2700X is the only model to have the ghost Wraith Prism and it's the only 105-watt TDP piece, so that requires a beefier cooler, this model weighs 580 grams.






Then Ryzen 7 2700 and Ryzen 5 2600X get the Spra Wraith, this model tipped the scales to 372 grams, making it 36% lighter, but it still sports a copper slug in the base. Then we have the non-X 2600 that gets the little Wraith Stealth weighing just 317 grams, making it 15% lighter than the Spire and a whopping 45% lighter than the Prism.



Also read: The Best CPU Coolers 2018



Those who bought the Ryzen 5 2600 may want to know if it's worth buying the Wraith Spire or the Prism second hand, there will always be on eBay. Likewise, those who have a 2600X or 2700 will want to know how prism is better than the Spire.



So we are going to compare the three coolers on the Ryzen 5 2600 using the stock settings as well as an overclock at 4 GHz. We will monitor CPU and VRM temperatures during an hour-long workload for Blender, as well as a 30-minute Overwatch gaming session.





The coolers will also be tested inside the DeepCool New Ark 90, a large ATX full enclosure equipped with a pre-installed all-in-one liquid cooler.



Of course, when I use coolers, the AIO will not be used, but I like the fact that four 140mm fans are pre-installed, although they are all configured as extraction fans, so I recommend you to install some of them. inlet fans mounted at the front. For this test although I went with the limited air flow configuration as the test point inside a case and not on the bench. try to simulate more realistic conditions that you would use these air coolers.



It's winter here right now so we test in a cool 20 degree room such as it is.










Benchmarks





First, I measured peak temperatures after 30 minutes of play during our Overwatch bot stress test. Using the Wraith Prism saw the 2600 peak at only 47 degrees which is very cool and the VRM has never exceeded 43 degrees, these are exceptional temperatures for a reasonably heavy game load, speaking of the use of the processor is around 50%. Because of these low temperatures, the Prism fan never runs faster than 1600 rpm and at this speed it is virtually silent.



The move to the Wraith Spire increased the charge temperature by 6 degrees and although the CPU was warmer, the Spire fan speed did not exceed 1700 RPM, so the operating volume was about the same. even. VRM times also remained about the same.



Then, with the Wraith Stealth, we see an additional 7 degrees increase for the charging temperature and now things are starting to heat up to 60 degrees. Remember that we are only half pushing the CPU in this test, so let's go for a 100% load test with Blender.





Running Blender for an hour increases the charge temperature of Wraith Prism to 57 degrees. This is an increase of 10 degrees compared to what we saw while playing. The fan speed also increased to 2000 rpm, but even here, the prism was still basically silent. This time, the Wraith Spire was 8 degrees warmer than the Prism, while the weather reached 65 degrees, though it was still very cool by all accounts and the fan was running at 2000 rpm.








Then with the cooler that comes with the 2600, the Wraith Stealth we see temperatures reach 72 degrees and now we get up. Ideally, you do not want temperatures above 70 degrees for prolonged use. That said, you can increase the fan speed for better results because even the Stealth was running at just 2,000 rpm. I should note however that the Spire and Stealth do a good job of pushing the air above the VRM from the motherboard.





Overclocking the R5 2600 by pushing all cores to 4 GHz using 1.2 volts did not increase the operating temperature of the processors by a few degrees in overwatch. The speeds of the fans also remained substantially the same. The temperature of the VRM has risen from 4 to 5 degrees, but at less than 40 degrees C, this is not disturbing. This uses a high-end X470 card, but still very cool temperatures on the VRM.





Now, for the Blender test at 100% load, the Wraith Prism reaches 63 degrees, or 6 degrees higher than what we saw for the stock test and now it is possible to hear the fan turn up to 2200 RPM.



The Wraith Spire allows the overclocked R5 2600 to reach 70 degrees and with the fan running at 2700 RPM, it's pretty easy to hear. The Wraith Stealth also reached 2700 RPM, making it reasonably strong and despite temperatures still reaching 87 degrees, this represents an increase of nearly 40% in the operating temperature of the Prism.





Before moving on, here's a quick look at the comparison between Spire and Prism and the ultra-affordable Gammaxx 200T DeepCool. Currently, this 120mm tower cooler costs $ 15 on Amazon and seems to be a very good upgrade for the owners of Ryzen 3 2200G and R5 2400G as these two APUs come with the Wraith Stealth.








For Ryzen 5 2600 owners, this will earn you Wraith Prism performance when you play, but it's worth noting that the 120mm fan is much better at cooling down the VRM on our X470 board. The Gammaxx 200T also seems to be a decent upgrade option for owners of the R5 2600X and R7 2700.





With the Ryzen 5 2600 under 100% load in our Blender workload, the Gammaxx 200T is more comparable to the Wraith Spra, which makes it a bit warmer than the Prism. Although less impressive in these conditions, it's still a solid update option for Wraith Stealth owners.



Conclusion



We hope that those of you who are building a new Ryzen system who wanted to see how Stealth, Spire and Prism compare themselves are satisfied with this test. If you have a Ryzen 5 2600 or any other AMD processor supplied with the Wraith Stealth, you will ideally want to upgrade the cooler for better thermal performance, especially if you plan to overclock.



It seems that many of you want to stay with an AMD brand cooler and although I agree, they look nice, it 's not really a cost effective option. Looking at places like eBay, it seems that most Wraith Prism coolers are selling around $ 40 + shipping, for this kind of money you can get a seriously good air cooler.





Remember that the Deepcool Gammaxx 200T is a very affordable economical option ($ 15) and even that's not much worse than the Prism at less than 100% charge. In fact, I'm willing to bet that the slightly larger Gammaxx 300 is able to outperform the Prism.



If you can do without the AMD branding, then I suggest you look elsewhere for your cooler upgrade, conversely if you want to know if this cooler Stock is good, for the most part they are pretty decent.



[ad_2]

Source link

Post a Comment

Cookie Consent
نستخدم ملفات تعريف الارتباط على هذا الموقع لتحليل حركة المرور، وتذكر تفضيلاتك، وتحسين تجربتك.
Oops!
يبدو أن هناك مشكلة في اتصالك بالإنترنت. يرجى الاتصال بالإنترنت والبدء في التصفح مرة أخرى.
AdBlock Detected!
لقد اكتشفنا أنك تستخدم إضافة حظر الإعلانات في متصفحك.
الإيرادات التي نحصل عليها من الإعلانات تُستخدم لإدارة هذا الموقع، نطلب منك إضافة موقعنا إلى قائمة الاستثناءات في إضافة حظر الإعلانات الخاصة بك.